Philips Onis 200 Manual De Instrucciones página 18

2uk onis suppl 19/07/01
Registering the handset with a base station
In order to use the HANDSET with the BASE STATION, you must first follow
the procedure described below. Each HANDSET may be used with two different
BASE STATIONS.
L
WARNING:
Before commencing the following, the handset must be fully charged for at least 12 hours.
ONIS 200 or ONIS Vox 200 base stations
Unplug and plug back in the power supply of the Onis 200 BASE STATION.
1
Scroll to "Register hdset" under "Handset settings" in the "Settings" menu and
2
select OK|.
Enter the base station registration code (4 figures) and select OK|.
3
The screen will display "Recording..." for a short while, followed by "Set!" once
4
the procedure is complete.
In the event of failure, begin again from step
Another base station
First, follow the procedure described by the manufacturer (see base station
manufacturer's instructions).
Once this is done, follow steps
HANDSET.
Cleaning your handset
Use a damp, lightly soaped cloth to clean your HANDSET.Wipe with a dry cloth.
• Never use a solvent or household product. Clean your telephone regularly to
keep it looking brand new.
Important:
Do not place your telephone in a place where it may fall.
5
11:15 Page 5
.
1
to of the procedure shown above for the
2 4
Additional Onis 200 handset
The code is shown on the label beneath the
base station bottom (RC).