Philips Onis 200 Manual De Instrucciones página 25

2uk onis suppl 19/07/01
Select |SWITCH to place the internal call on hold and speak to the person
3
on the external line. Using this function, it is possible to switch between
internal and external lines.
• Select TRANSF.| to forward the external call to your chosen handset.
• Scroll to and select CONF. CALL| to set up a conference call between the
external caller and two internal handsets.
On the handset(s) called:
Press to answer.
Using the babysit function
Acts as a silent intercom, while another handset is used as an intercom monitoring
handset to listen to noise in the room where the former monitoring handset has
been placed. If you receive a call, the intercom will remain silent and will not take
the call.
Activating babysit mode
Scroll to "Babysit mode" under the "Handset settings" heading in the "Settings"
1
menu and select OK|.
Scroll to activate the function and select OK|.
2
Deactivating the babysit mode
On the idle screen shown, select CANCEL|.
Using the intercom
In order to listen to noises picked up by the monitoring handset, you will need to
set up the intercom (see page 11) between the handsets.
L NOTE:
Handsets in "Babysit" mode can still be used to make calls, but will not ring when a call
is received.
11:16 Page 12
Additional Onis 200 handset
You can also hang up by pressing
The "Babysit mode" indicator then appears
on the idle screen.
You can deactivate the babysit mode using
the "Babysit mode" menu, following the
same procedure as that used to activate the
mode.
12
.