Factory Default Reset; Emergency Key Override - Schlage BE468 Serie Guia Del Usuario

FACtoRy DeFAuLt ReSet

When should you perform a Factory Default Reset?
• If you want to move the lock to a different door, you need to restore default settings, move the lock to the new door, and then set up the
lock again.
• If you have forgotten your Programming Code, you can restore the default codes.
1. Disconnect the batteries. See Replacing the Batteries on page
4.
2. Press and hold the Schlage Button.
3. While holding the Schlage Button, reconnect the batteries.
4. Release the Schlage Button.
L If you are moving the lock to a new door, install the
lock on that door before continuing.
5. To check that the lock was reset, press the Schlage Button
and enter one of the Default User Codes. See Default Codes
Locations on page 7.
6. If the reset was successful, the lock will perform a setup routine. Wait until the bolt stops moving. The reset and setup are complete.
7. Z-Wave network settings are maintained thorugh Factory Default Reset.

emeRgeNCy key oVeRRIDe

Emergency Key Override can be used when the battery is completely dead, or when no valid User Code is known.
Insert key and rotate to unlock, just like any lock. See Replacing the Batteries on page 4.
This lock may be rekeyed to match other locks in a residence. Contact a locksmith for assistance.
WARNING
Locate the default Programming and User Codes on the back of
the Interior Assembly before beginning! Default Programming and
User Codes will be restored. All existing User Codes and current
Programming Code will be erased.
CUSTOMER SERVICE CANNOT RETRIEVE LOST DEFAULT
CODES! DO NOT RESTORE FACTORY SETTINGS UNLESS YOU
CAN LOCATE ThE DEFAULT CODES.
9