Replacing The Batteries; Locking And Unlocking; Locking From The Outside; Locking From The Inside - Schlage BE468 Serie Guia Del Usuario

RePLACINg tHe BAtteRIeS

»
Replace the batteries in your lock at the same time each year that you test and replace the batteries in your smoke alarms. This will
ensure continued reliable operation.
»
Use four high-quality alkaline AA batteries for replacement. Lithium batteries may cause undesirable operation.
1. Remove the inside cover.

LoCkINg AND uNLoCkINg

»
If you make a mistake while entering a User Code, press the Schlage Button and then start again.

Locking from the outside

1. Press the Schlage Button.
2. The lock will lock. The green check mark will light once.
»
If the bolt cannot fully extend, the red X will light and a tone will
sound. The door may remain unlocked!
»
If the Lock & Leave feature is disabled, a valid User Code must
be entered to lock the door. See Enable/Disable Lock & Leave
on page 6.

Locking from the Inside

Rotate the Inside Thumbturn.
4
ELECTrosTaTiC DisChargE Warning!
DO NOT TOUCH the circuit board! You may damage the lock.
2. Unsnap the battery connector,
remove the battery tray and
replace the batteries.
3. Replace the battery tray with the batteries
facing the door. Snap the battery connector
to the tray and replace the cover.

unlocking from the outside

1. Press the Schlage Button to turn on the backlight.
2. Enter a valid User Code.
3. The green success check mark will flash twice and one beep will
sound. The deadbolt will unlock.
»
If the red error X lights, the User Code was not valid.

unlocking from the Inside

Rotate the Inside Thumbturn.