Installing On Boyler; Fitting To The Boiler - Electrical Connections - baltur BTL14P Manual De Instrucciones

TWO STAGE LIGHT OIL BURNERS
N° 0002934100

INSTALLING ON BOYLER

Rev. 10/02/2004
1) Lock the flange B on the tube of the burner via the supplied screw A and nut C (n° 2 x BTL 20).
2) Position the insulating seal E on the tube, interposing the cord F between flange and seal.
3) Finally, fix the burner to the boiler via the 4 stud bolts and relative nuts (supplied).
N.B. Make sure the tube penetrates into the combustion chamber as per the boiler manufacturer's
instructions.
ELECTRICAL CONNECTIONS
The electrical lines should be at an adeguate distance from hot parts.It is advisable to make all the connections
with flexible elecric wire. Conductor's minimun section 1,5 mm .
2
19