Maintenance; General Recommendations; Electric Pressure Washer Maintenance - Briggs & Stratton PW101-2010 Manual Del Operador

Ocultar thumbs Ver también para PW101-2010:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Press TEST button (B). The indicator light (D) should be OFF.
B
D
4. Press RESET button (C). The indicator light (D) should be ON.
NOTICE DO NOT use the electric inflator if above test fails.
5. The electric inflator comes equipped with three adapters.
When an adapter is required to inflate an object, lift lever (E)
and insert the appropriate adapter (F) into the inflator hose
end (G). Move lever down to secure the adapter.
E
G
6. Press the master ON/OFF switch (A) to the Inflator ON (=)
position.
7. Insert adapter into the object to be inflated. When inflated,
remove adapter and press the master ON/OFF switch (A) to
the OFF (O) center position.
8. When inflating tires, connect the inflator hose end directly to
the tire stem. When inflated, remove inflator hose end and
press the master ON/OFF switch (A) to the OFF (O) center
position.
9. Disconnect GFCI plug from outlet and coil power cord.
C
F

Maintenance

General Recommendations

Regular maintenance will improve the performance and extend
the life of the electric pressure washer.
The electric pressure washer's warranty does not cover items that
have been subjected to operator abuse or negligence. To receive
full value from the warranty, the operator must maintain the
electric pressure washer as instructed in this manual, including
proper storage.
NOTICE Should you have questions about replacing components
on your electric pressure washer, please call (800) 743-4115 for
assistance.
Before Each Use
1. Clean debris.
2. Check water inlet screen for debris or damage.
3. Check high pressure hose for leaks.
4. Check detergent siphoning tube for damage.
5. Check spray gun operation.

Electric Pressure Washer Maintenance

Clean Debris
Daily or before use, clean accumulated debris from electric
pressure washer. Inspect cooling air slots and openings on the
front, rear and bottom of the electric pressure washer. These
openings must be kept clean and unobstructed.
The electric pressure washer parts should be kept clean to reduce
the risk of overheating and ignition of accumulated debris.
• Use a damp cloth to wipe exterior surfaces clean.
NOTICE Improper treatment of the electric pressure washer can
damage it and/or shorten its life.
• DO NOT insert any objects through cooling slots.
Check and Clean Water Inlet Screen
Remove water inlet coupling (A). Then remove water inlet screen
(B) from the unit's water inlet (C) using a needle nose pliers.
Water inlet is located at bottom front of unit. Examine water inlet
screen. If the screen is dirty, clean with a small brush and water.
If the screen is damaged, replace it.
C
A
B
NOTICE If inlet screen is damaged or missing, DO NOT use
electric pressure washer. Call (800) 743-4115 for assistance.
17

Publicidad

Tabla de contenido
loading

Tabla de contenido