Assemble Main Unit - Briggs & Stratton PW101-2010 Manual Del Operador

Assemble Main Unit

When performing the following assembly procedures, pay close
attention to the illustration at the bottom of this page.
1. Remove and discard the protective cap (A) from each wheel
shaft.
NOTICE During shipment wheel tabs may compress inward. If
so, gently spread tabs outward.
2. Slide wheel shafts (B) into holes at sides of main unit (C).
Wheels are installed correctly when you hear a CLICK and
they are securely in place.
F
8
A
C
B
G
H
3. Slide the handle (D) into the slots at top of main unit. Install
two (2) screws to secure the handle to the main unit.
4. Slide accessory tray (E) into slots at back of main unit. Install
two (2) screws to secure the accessory tray to the main unit.
5. Install stability foot (F) if equipped, and secure using two
screws.
6. Confirm that black rubber gasket (G) is installed in water inlet
located at lower front of unit.
7. Place detergent bottle (H) onto shelf at back of unit.
8. Rotate detergent bottle cap (J) counter-clockwise until it
clicks onto retaining tab. Make sure that end of suction hose
contacts bottom of bottle.
D
B
E
J
BRIGGSandSTRATTON.COM