Tabla de contenido
Publicidad
Power Nozzle Storage
Thermal Protector
- 36 -
➢ The wand has a "U" shaped flange
that slides into the "U" shaped slot
on the canister.
➢ The slot allows the wands and
Power Nozzle to be stored with the
canister to conserve storage space.
The canister must be stored on end
for this feature to be used.
➢ The wand will slip out of the slot as
it is lifted up for use and will slide
into the slot as it is lowered for
storage.
➢ The Power Nozzle must be in the flat
position as shown in the illustration.
Use the handle release pedal to
place it in this position.
➢ If a clog prevents the normal flow of
air to the canister motor, the thermal
protector turns the motor off
automatically to allow the motor to
cool in order to prevent possible
damage to the vacuum cleaner.
➢ To correct problem, turn off and
unplug vacuum cleaner, remove
clogs, and/or clean/replace filters.
➢ Replace full bag if necessary.
➢ Wait approximately fifty (50) minutes,
plug vacuum cleaner in, turn on to
see if thermal protector has reset.
Publicidad
Tabla de contenido
