Installing Batteries - HoMedics BPW-360BT Manual Del Usario

Monitor de presion arterial para la muneca de primera calidad
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING BATTERIES

1. T he battery cover is located along the
side of the monitor. Remove battery
cover by pressing down and pulling
away from the monitor.
2. Install batteries according to the
polarity indications inside the
compartment (as shown in figure
2). Battery Type: 2 Alkaline LR03
(1.5v AAA) size
3. Insert the other battery, according
to the polarity indications inside the
compartment (as shown in figure 3).
4. Replace the cover by inserting it
back into place.
1.
2.
3.
4.
11
Replace the batteries if:
• T he weak battery symbol "Lo" appears on the display.
• N othing appears on the display when the power is
switched on and the START/STOP button is pressed.
As the supplied batteries are for test only, they may be
discharged earlier than batteries you buy in stores. Replace
all batteries at one time (as simultaneous set). Use only
1.5v AAA alkaline batteries. Remove batteries when the unit
is not in use for extended periods of time. Date and time
will need to be reset if batteries are removed or replaced.
Clean contacts on battery and in battery compartment with
a soft dry cloth each time you install batteries.
Note:
Batteries are hazardous waste. Do not dispose of them
together with the household garbage.
12

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido