Hatco TOAST-QWIK TQ-10 Serie Manual De Instalación Y Funcionamiento página 7

WARNINGS
To assure safe and proper operation while operating in
the Front Discharge mode, allow a minimum clearance
of 25 mm (1") along the sides and rear. Allow a
minimum clearance of 305 mm (12") along the front.
To assure safe and proper operation while operating in
the Rear Discharge mode, allow a minimum clearance
of 25 mm (1") along the sides. Allow a minimum
clearance of 305 mm (12") along the front and rear.
To prevent any injury or damage do not pull unit by
power cord.
To prevent any injury, discontinue use if power cord is
frayed or worn.
If the Warning light on the control panel is lit, appliance
is malfunctioning. Turn OFF the power to the unit and
allow to cool. Once cool, disconnect appliance from
power supply and have unit serviced by a qualified
technician.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the Hatco
Service Department at 414-671-6350; International fax
414-671-3976.
This product has no "user" serviceable parts. To avoid
damage to the unit or injury to personnel, use only
Authorized Hatco Service Agents and Genuine Hatco
Parts when service is required.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement Parts
may subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
IMPORTANT SAFETY INSTRUCTIONS
Some exterior surfaces on the unit will get hot. Use
caution when touching these areas to avoid injury.
To avoid damage to the unit or injury to personnel
always operate toaster with crumb tray installed.
To avoid any injury, do not remove the crumb tray for
cleaning until toaster is cool.
Unit is not weatherproof. For safe and proper operation
the unit must be located indoors where the ambient air
temperature is a minimum of 70°F (21°C) and a
maximum of 85°F (29°C).
Do not locate the toaster in an area subject to
excessive temperatures or grease from grills, fryers,
etc. Excessive temperatures could cause damage to
the unit. Do not place toaster in an area that restricts
air flow around the front or rear of the unit. Do not
place toaster in direct discharge path of air
conditioning vent or makeup air vent.
Use only non-abrasive cleaners. Abrasive cleaners
could scratch the finish of your Toast-Qwik toaster
marring its appearance and making it susceptible to
soil accumulation.
7
CAUTIONS
CAUTIONS
Form No. TQ2CEM-1105