Fein MultiMaster FMM250 Instrucciones De Uso página 12

3 41 01 091 21 0.book Seite 12 Montag, 29. Juni 2009 8:32 08
en
12
Changing the tool.
The application tool can be fastened offset at convenient working positions at 45° steps
(or at 30° steps for the triangle-shaped sanding pad).
M M FMM250Q (Figure 3).
ULTI ASTER
Before mounting or replacing
WARNING
application tools or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of injuries
through accidental starting of the power tool.
For all work or when changing
CAUTION
application tools, always wear
protective gloves. Danger of injury from the
sharp edges of the application tools. Applica-
tion tools can become very hot while work-
ing. Danger of burns!
Protect your hand and fingers
CAUTION
from being bruised/crushed
from the snapping back quick-clamping lever.
The quick-clamping lever pivots back power-
fully due to the spring force.
Firmly press in the fastening element to
the stop. Then lock the rapid-clamping
lever.
Loosen the quick-clamping lever and
swivel it to the stop.
Pull out the fastening element.
Clean the tool holder, the application
tool and the fastening element.
Place the application tool exactly onto
the star-shaped tool holder. Pay atten-
tion that the application tool has a flush
fit.
Insert the fastening element to the
stop into the tool holder.
Swivel the quick-clamping lever back
until it engages.
Fig. 3 Fastening element
Tool holder
Quick-clamping
lever
180°