Fein MultiMaster FMM250 Instrucciones De Uso página 6

Ocultar thumbs Ver también para MultiMaster FMM250:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3 41 01 091 21 0.book Seite 6 Montag, 29. Juni 2009 8:32 08
en
6
– Avoid overheating the material being
sanded and the power tool.
– Empty the dust collector/container in time.
Hand/arm vibrations
While working with this power
WARNING
tool, hand/arm vibrations
occur. These can lead to health impairments.
The vibration emission value
WARNING
during actual use of the power
tool can differ from the declared value depend-
ing on the ways in which the tool is used.
It is necessary to identify
WARNING
safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use.
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 60745 and may be used to compare one
tool with another. It may be used for a pre-
liminary assessment of exposure.
Emission values for sound and vibration (Two-figure – specifications as per ISO 4871)
Sound emission
Measured A-weighted sound power level L
(re 1 pW), in decibels: 85
Measuring uncertainty K
A-weighted emission pressure power level
measured at the workplace L
decibels: 74
Measuring uncertainty K
REMARK: The sum of the measured emission
value and respective measuring inaccuracy
represents the upper limit of the values that
can occur during measuring.
Wear ear protection!
Measured values determined in accordance
with the corresponding product standard.
– Observe the material manufacturer's work-
Observe the relevant regulations in your
country for the materials being worked.
The declared vibration emission level repre-
sents the main applications of the tool. How-
ever if the tool is used for different applications,
with different accessories or poorly maintained,
the vibration emission may differ. This may sig-
nificantly increase the exposure level over the
total working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may
significantly reduce the exposure level over the
total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
wA
, in decibels: 3
wA
(re 20 µPa), in
pA
, in decibels: 3
pA
*These values are based on a work cycle con-
sisting of no-load and full-load operation of
the same duration.
For information on the vibration class
assigned to the application tool, please see the
enclosed data sheet 3 41 30 335 06 0.
ing instructions.
Vibrations
Classification of FEIN
application tools accord-
ing to vibration class
VC0
VC1
VC2
VC3
VC4
VC5
Weighted
acceleration*
2
< 2.5 m/s
2
< 8 ft/s
2
< 5 m/s
2
< 16 ft/s
2
< 7 m/s
2
< 23 ft/s
2
< 10 m/s
2
< 33 ft/s
2
< 15 m/s
2
< 50 ft/s
2
> 15 m/s
2
> 50 ft/s

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Multimaster fmm250q

Tabla de contenido