Fein MultiMaster FMM250 Instrucciones De Uso página 15

3 41 01 091 21 0.book Seite 15 Montag, 29. Juni 2009 8:32 08
Sanding
Typical application: Dry sanding of wood and
metal, especially of smaller surfaces, corners
and edges, as well as hard to reach locations.
Work with the complete surface of the sand-
ing plate, not only with the tip. Select a high
oscillating frequency. Sand with continuous
motion and light pressure. Applying excessive
pressure does not increase material removal;
only the sanding sheet wears more quickly.
Sawing
Typical application: Sawing of thin steel sheet,
wood and plastic components.
Select a high oscillating frequency.
Round saw blades can be clamped offset again
to provide uniform wear.
Scraping
Typical application: Scraping off old coats of
varnish or adhesives, removing bonded car-
peting, e. g., on stairs/steps or other small/
medium-sized surfaces.
Select a medium to high oscillating frequency.
Storage
(M M FMM250Q - Figure 3).
ULTI ASTER
Before carrying out adjust-
WARNING
ments on the power tool,
replacing accessories or placing down the
power tool, pull the plug from the socket outlet.
This safety measure prevents accidental start-
ing of the power tool.
Engage the quick-clamping lever.
Fully insert the fastening element into
the tool holder in order to protect it
against damage and contamination.
en
15