Adjusting The Axle Shafts And Brakes Unlocking Side Levers - EMAK TN 3500 Manual Uso Y Mantenimento

7. Adjusting the axle shafts and
brakes unlocking side levers
CAUTION
o Make sure to tighten the side
levers assembly screws properly.
o If the machine does not turn in a
proper way when the unlocking le-
ver (A) is pressed, adjust it by us-
ing adjuster (B).
o If the machine does not turn in a
proper way when brake lever (C) is
pulled, adjust it by using adjuster
(D) whilst keeping clutch lever in
engaged position (see figure).
8. Adjusting the parking brake
CAUTION
o Adjust the brake in order to
keep it efficient and so that is does
not create resistance when not
necessary.
o Check brake efficiency with
clutch lever in release position
(parking brake position).
If brakes are ineffective, adjust ten-
sion on the brake load spring (A)
and make hook (B) run along the
slot after loosening screw (C) and
afterwards screwing down. To fa-
cilitate this operation, keep clutch
lever engaged.
29