Unpacking And Inspection - Amprobe AM-520 Manual Del Usuario

Ocultar thumbs Ver también para AM-520:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Measurement Category II (CAT II) is for measurements performed on circuit
directly connected to low voltage installation. Examples are measurements on
household appliances, portable tools and similar equipments.
X�
Warning: Read Before Using
• To avoid possible electrical shock or personal injury, follow these
instructions and use the Meter only as specified in this manual.
• Do not use the Meter or test leads if they appear damaged, or if the
Meter is not operating properly. If in doubt, have the Meter serviced.
• Always use the proper function and range for measurements.
• Before rotating the function range selection switch, disconnect test
probe from circuit under test.
• Verify the Meter's operation by measuring on a known voltage source.
• Do not apply more than the rated voltage, as marked on the Meter,
between the test probe or between any test probe and earth ground.
• Use the Meter with caution for voltages above 30 Vac rms, 42 Vac peak,
or 60 Vdc. These voltages pose electrical shock hazards.
• Disconnect circuit power and discharge all high-voltage capacitors before
testing resistance.
• Do not use the Meter around explosive gas or vapor.
• When using the test leads, keep your fingers behind the finger guards.
• Remove test leads from the Meter before opening the Meter case or
battery door.

UNPACKING AND INSPECTION

Your shipping carton should include:
1
AM-520 or AM-530
1
Pair of test leads
1
Temperature probe
1
Velcro strap
1
9V (6F22) battery (installed)
1
User manual
1
Carrying case
If any of the items are damaged or missing, return the complete package to
the place of purchase for an exchange.
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Am-530

Tabla de contenido