Vollrath Dry Well Drop-ins Manual Del Operador página 4

OPERATION (CONTINUED)
Plug in the Equipment
Plug the equipment into a grounded electrical outlet that matches the rating on the name plate.
NOTICE: Using a voltage other than the nameplate rated voltage, or modifying the power cord or electrical components,
may damage equipment and will void the warranty.
NOTICE: This equipment requires a dedicated electrical circuit.
The Vollrath logo on the control panel(s)
and main power switch (multi-well drop-ins
only) will illuminate and remain lit while the
drop-in is plugged in, even if the induction
capsules are turned off.
Turn On Main Power
Multi-well drop-ins
1. Press to turn on power to the drop-in.
2. The induction capsules and wells will default to the settings from the
previous use.
The Display Will Show
Display Description
160
HI
The display for one or both induction
or
capsules shows a STEADY temperature or
160
HI
power level.
160
The display for one or both induction
capsules show OFF.
OFF
160 HI
The display for one or both induction
or
capsules is FLASHING a temperature or
160 power level.
HI
BAD
PAN
The display for one or both induction
capsules is FLASHING BAD PAN.
160
160
4
Single well drop-ins
1. Press to turn on well.
2. The induction capsules will default to the settings from the previous
use.
Status
A Vollrath induction-ready pan is making contact with induction capsule
and the capsule is warming the pan.
Power to the corresponding induction capsule is turned off.
There is not a pan in the well.
There is a 2¹⁄₂" inch deep pan in the well but the induction capsule is set
for a 4" deep pan, therefore the pan is not detected. See "Adjust the
Induction Capsules to Accommodate the Pan(s)" on page 3.
The pan in the well is not a Vollrath induction-ready pan. See "Insert
Pans of Prepared Hot Food" on page 3.
Modular Induction Dry Well Drop-ins Operator's Manual