Safety Information; Installation - Tuthill Fill-Rite 3200 Serie Manual De Instalación, Operación Y Seguridad Del Propietario

Safety Information

WARNING! Electrical wiring should be performed ONLY by a licensed
electrician in compliance with local, state, and national electrical code NEC/
ANSI/NFPA 70, NFPA 30, and NFPA 30A, as appropriate to the intended use of
the pump. Threaded rigid conduit, sealed fittings, and conductor seal should be
used where applicable. The pump must be properly grounded. Improper
installation or use of this pump can result in serious bodily injury, or death!
WARNING! To insure safe and proper operation of your equipment, it is critical
to read and adhere to all of the following safety warnings and precautions.
Improper installation or use of this product can cause serious bodily injury or
death!

NEVER smoke near the pump, or use the pump near open flames when
pumping a flammable liquid! Fire can result!

A Fill-Rite Filter should be used on the pump outlet to insure no foreign
material is transferred to the fuel tank.

Threaded pipe joints and connections should be sealed with the appropriate
sealant or sealant tape to minimize the possibility of leaks.

Storage tanks should be securely anchored to prevent shifting or tipping
when full or empty.

To minimize static electricity build up, use only static wire conductive hose
when pumping flammable fluids, and keep the fill nozzle in contact with the
container being filled during the filling process.

The pump motor is equipped with thermal overload protection; if
overheated, the motor will shut off to prevent damage to the windings. If
this happens, you must turn the power off to the pump to reset this safety
feature, and turn the pump back on when cool to continue use.
WARNING! This product shall not be used to transfer fluids into any type of
aircraft.
WARNING! This product is not suited for use with fluids intended for human
consumption or fluids containing water.

Installation

The Fill-Rite 3200 Series pump is designed to be mounted on a skid tank using the
threaded inlet flange supplied with the pump (see attached diagrams),
The FR3200 series pump features an integral bypass valve recirculate the fluid when the
pump is operating with the nozzle closed.
WARNING! In Skid Tank applications, be sure the tank is properly secured so it
cannot shift or move when the tank is empty or full.
CAUTION! Do not use additional check valves or foot valves unless they have a
proper pressure relief valve built into them. Note that additional check valves will
reduce rate of flow.
3