Abicor Binzel ABIROB A Serie Instructivo De Servicio página 25

®
ABIROB A
When equipped with the ROBO hose assembly, the welding torch system ABIROB
For the initial assembly, additional components are required which depend on the welding task at hand.
They include the following:
• Torch neck (in the preferred size and geometry) • Mount (required for fastening to the robot)
• Set-up parts and wearing parts (order separately)
Tab. 6 Components
4.1 TransTransport
Checking procedure on
receipt of goods
In case of damage
In case of complaints
Packaging for returning
the goods
Tab. 7 Transport
4.2 Storage
The hose assemblies for the welding torch system ABIROB
in the standard lengths 1 - 3.5 m or in customer-specific lengths. For a complete
system, you will require a setting device. It must be ordered separately
depending on the configuration. Order data and part numbers for the set-up
and wearing parts can be found in the current ABICOR BINZEL spare and
wearing parts lists.
The components are carefully checked and packaged, however damage may
occur during shipping.
Check that the shipment is correct by referring to the shipping note.
Check the package and components for damage (visual inspection).
If the goods have been damaged during transport, contact the last
carrier immediately. Keep the packaging (for possible checks by the
carrier).
Use the original packaging and the original packaging material. If you
have questions concerning the packaging and safety during shipment,
please consult your supplier.
Physical storage conditions in a closed room:
 Tab. 2 Temperature on page EN-4
4 Components
®
A is not functioning.
®
A are available
EN - 7