Articulating Tablet Holder Mount - Segway 24078-00001 Manual De Instalación

Articulating Tablet Holder Mount

24052-00001
Tools required
• None
Installation
1. Make sure the PT is powered off and unplugged.
2. Install the extension arm onto the Tablet Holder mounting ball, then
mount the Tablet Holder and extension arm to one of the mounting balls
on the Handlebar Accessory Mount Base.
3. Orient the Tablet Holder to your preference, then tighten the extension
arm securely.
NOTE
Be sure to periodically check the tightness of all fasteners and the
extensions.
Removal
1. Loosen the extension arm, then remove the Tablet Holder and extension
arm from the Handlebar Accessory Mount Base.
NOTE
Refer to the Weight Limits and Maximum Allowable Cargo Weight
sections (p. 3) before using this accessory.
Do not use tablet while riding. This will interfere with your ability to
monitor your surroundings while riding, which can lead to an increased
risk of serious injury, death, or damage to property from falls or
collisions.
Parts
(1) RAM ® X-grip Tablet Holder
(1) 5.25-inch extension arm
13
IMPORTANT
Be sure to read and understand all
warnings (p. 3) at the beginning of
this Installation Manual.
Tighten here
Figure 18. Install Tablet Holder
Mounting Ball