Fuels - Desa TA100 Manual Del Propietário

12. Lift handle assembly over heater. Align
and guide bolts into holes in leg.
13. Secure assembly with nuts (E) (see
Figure 10).
14. Tighten entire assembly with tools.
Handle Assembly
Leg
Nut (E)
Figure 10 - Handle and Leg Assembly
WARNING: Use only kero-
sene, #1/#2 diesel/fuel oil, JET
A or JP-8 fuels to avoid risk
of fire or explosion. Never
use gasoline, oil drained from
crankcases, naphtha, paint
thinners, alcohol or other highly
flammable fuels.
Use only kerosene, #1/#2 diesel*/fuel oil,
JET A, JP-8 fuels. Heavier fuels such as No.
2 fuel oil, No. 2 diesel fuel may also be used
but will result in:
• noticeable odor
• additional fuel filter maintenance
* Use of #2 diesel/fuel oil in extreme cold
temperatures may require nontoxic anti-icer
additives.
118419-01D
aSSemBly
Continued
15. Assemble extension cord wrap to each
rear handle (see Figure 11).
16. Push handle grips onto handles (see
Figure 11).
Figure 11 - Handle Grip and Cord Cleat

FuelS

Do not use fuels heavier than No. 2 grade
or heavy oils such as oil drained from crank-
cases. These heavy oils will not ignite properly
and will contaminate the heater.
IMPORTANT: Use a KEROSENE ONLY (blue)
or DIESEL ONLY (yellow) storage container.
Be sure storage container is clean. Foreign
matter such as rust, dirt or water will cause the
ignition control assembly to shut down heater.
Foreign matter may also require heater's fuel
system to be frequently cleaned.
www.desatech.com
Extension
Cord Wrap
Assembly
Handle
Grip
7