Desa TA100 Manual Del Propietário página 6

5. Lift front of heater so it is resting on back of
shroud and back of legs (see Figure 8).
6. Insert axle through wheel. Slide one
spacer (B) onto each end of wheel axle.
See Figure 6.
7. Assemble wheel axle into front holes of
legs (see Figure 7).
8. Secure front legs to tank with two bolts
(C) (see Figure 8).
9. Tighten bolts from step 4 securing legs to
rear cross support.
10. Set heater down to floor on wheel and rear
legs.
11. Slide rear handle onto each end of front
handle. Insert bolts (D) into holes (2 per
side) (see Figure 9).
Spacer
(B)
Axle
Figure 6 - Wheel and Axle
Figure 7 - Installing Wheel and Axle
6
aSSemBly
Continued
Figure 8 - Attaching Legs to Tank
Wheel
Wheel
Front
Handle
Leg
Figure 9 - Front and Rear Handle
www.desatech.com
Rear
Handle
Assembly
118419-01D
Bolt (C)
Bolt (D)