Desa TA100 Manual Del Propietário página 9

WARNING: This heater is
equipped with a thermostat.
Heater may start at any time.
TO STOP HEATER
1. Push ON/OFF switch to the OFF (O)
position.
2. Unplug heater when not in use.
TO RESET HEATER
1. Push ON/OFF switch to the OFF (O)
position and wait 10 seconds. (Wait two
minutes if heater has been running.)
2. Repeat steps under To Start Heater,
page 8.
Temperature Display
This heater is equipped with a digital tem-
perature display. The temperature being shown
represents the air nearest to control cover.
The temperature of air in surrounding areas
may be much different from temperature be-
ing displayed. Display may show [
thermostat control or temperature sensor are
disconnected from control or if they are dam-
aged. If this occurs, control will continue to
operate as before, however, unit will not cycle
off during operation. See Figure 13.
Display Codes
C1 = Low Voltage
C2 = High Voltage
C3 = No Ignition
C4/C5 = Out of Fuel or Fault*
* See fault codes in your owner's manual.
LED display will show surrounding temperature unless up and down arrow keys are
pressed. After pressing these keys, display shows set point temperature for a second and
then will change back to display surrounding temperature.
This thermostat will store the last set point even if power is removed. Unit will maintain this
set point until a new set point is entered.
118419-01D
oPeration
Continued
Lighted ON/OFF
Switch
Temperature
Sensor
Error Codes
This heater will display error codes whenever
there is an abnormal shutdown or problems
with supply voltage. Make sure you have read
all instructions and see Troubleshooting, page
11, before attempting to rectify any problems
with your heater.
] when
heater while it is plugged in,
operating or hot. Severe burns
and electrical shock can occur.
Increase and Decrease
Temperature Setting
Figure 14 - Controls Display
www.desatech.com
Figure 13 - Control Cover with
Temperature Display
WARNING: Never service
Thermostat
Control
Temperature
Display
9