SOMFY HOME MOTION AXOVIA Passeo 600 Manual Del Usuario página 21

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2
Parametering your PASSEO/AXOVIA
I The steps:
J Presentation of the symbols.
J Parametering your PASSEO/AXOVIA.
J Using precautions for the automatic mode.
J Securization of parametering.
J Presentation of the symbols.
Maintain pressed
Press for 1
second / release
J Parametering your PASSEO/AXOVIA.
Before starting the parametering your installation, check that the ON/OFF and PROG
lights are lit and the DANGER
light is off. Do the following operations :
Functioning of the remote controle :
Your PASSEO /AXOVIA can function with one or several remote controls. The
operations described below must be repeated as often as there are remote controls
to memorize.
You can memorize one or two buttons on your remote control, each of the buttons
corresponding to a different functioning mode :
Blinking light
Lit light
2
Parametering your PASSEO/AXOVIA
Memorising the remote controls:
On each remote control, the first button memorized will control leaf opening completely.
Place the remote control against the target engraved on the hood and do the following
operations :
1
Maintain the button to be memorized
pressed until the PROG light blinks slowly
(the DANGER
light lights up during this
operation)
2
Release
the
button
:
it
is
memorized.
Repeat these operations for :
• the second button (pedestrian
opening),
• the other remote controls to be
memorized.
At the end of the memorization cycle, only the PROG and ON/OFF lights are lit, the
electronics waiting for memorization of leaf displacement
Memorisation of leaf displacement :
The Somfy electronics automatically memorizes :
• The force of the cylinders necessary for gate control in normal operation. This
memorization then makes it possible to detect any abnormal force on the motorization.
• The angles necessary for complete opening and closing of the gate leaves with
locating the stops. This memorization then makes it possible to slow down before
reaching on the stops.
In order to start up the memorization process with the LEAF CLOSED, stand at a normal distance from
the gate and respect the following steps :
1
• Push on the programmed button
designed for complete opening.
>After a few seconds, the gate
opens at low speed.
2
• Once the gate is open, push again on
the same button.
>The gate closes, one leaf after the
other.
5s
1s
21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Home motion axovia passeo 630Home motion axovia passeo 650

Tabla de contenido