Kenmore 790.3667 Serie Manual De Uso Y Cuidado página 18

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setting
Oven
Controls
(cont'd)
To Set for Broiling:
1,
2,
3,
Arrange the oven rack while oven is stHU cool Position the rack as suggested in the
Broit Rack Position Table bebw,
Press
"----
"wHU appear in dispUay,
Press and hoUdthe A
or V
until the desired broil setting bveU appears in the
dispUay, Press the A
for HI broil or the V
for LO broil, Most foods may be
broiled at the HI broil setting, Sebct the LO broil setting to avoid excess browning
or drying of foods that shouUd be cooked to the weft-done stage,
4,
PUace the insert on the broil pan, then place the food on the insert (See Fig, 1 ), DO
NOT use the broil pan without the insert or cover the insert with aluminum
foit,
The exposed fat could ignite,
5,
Place the pan on the oven rack, Close the oven door.
6,
Broil on one side until food is browned, Turn and broil food on 2nd side,
Note: Always pull the oven rack out to the stop position before turning or removing
the food,
broiling is finished, press _,
7,
When
Broit Rack Position
Table (Refer to Fig, 2)
Rack Postion from Top
Food category
1st rack position
Medium:rare steaks & hamburgers
2nd rack position
Fish, medium steaks & pork chops
3rd rack position
WelPdone foods such as chicken & lobster
Should an oven fire occur, close the oven door and turn the oven OFF,
If the fire continues, use a fire extinguisher, DO NOT put water or flour on the fire, Flour
may be explosive,
Figure 1
Note: The broiler pan and the
insert allows grease to drain
and be kept away from the
high heat of the broiler, DO
NOT use the pan without the
insert, DO NOT cover the
insert with foil; the exposed
grease could ignite,
@
/
j
Figure 2
To Operate
the Oven
Light
The interior oven light will automatically turn ON when the oven door is opened, Press
to turn the interior oven light ON and OFF whenever the oven door is closed,
The interior oven fight is located at the upper right rear waft of the oven interior and is
covered with a glass shield held by a wire holder, The glass shield must be in place
whenever the oven is in use, To change the interior oven light, see "Changing the Oven
Light" in the GeneraJ Care & Cteaning section,
18

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido