Generaj Cjeaning; Beforeyou Call - Kenmore 790.3667 Serie Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before You Calt
Solutions
to Common
Problems
Before you ca/I for service, review this Hst, Utmay save you time and expense, The Hst incUudes common occurrences
that are not the resuUtof defective workmanship or materiaUs in this appliance,
OCCURRENCE
Range is not level
POSSmBLE CAUSE/SOLUTmON
Poor instailation= Place oven rack in center of oven= Place a Ievel on the oven rack=
Adjust leveling legs at base of range until the rack is Ievel. When range is level,
cooktop may appear out of aIignment if countertop is not level.
Weak, unstabIe floor. Be sure floor is leveI and can adequately
support range. If floor
is sagging or slopping, contact a carpenter to correct the situation.
Kitchen cabinet misalignment
may make range appear to be unlevel. Be sure
cabinets are square and have sufficient
room for range clearance.
Cannot move appliance
easily.
Appliance
must be accessibme for
service.
Cabinets not square or are built in too tight. Contact a cabinet maker to correct the
problem.
Contact builder or installer to make appliance accessible.
Carpet interferes with range. Provide sufficient space so range can be lifted over
carpet.
Entire range or oven does not operate.
Gas line is hard-plumbed.
Have a flexible C.S.A international
approved metal
appliance
connector
installed.
Make sure cord/plug is plugged tightly into outlet.
iii_iiii!_i_
,_iii,,,i!_ili_
Service wiring is not complete. Call 1=800-4-MY=HOME ® (See back cover).
Electrical power outage. Check house lights to be sure. GalI your local electric
company for service. Surface burners can be Ht manually.
*Oven control
beeps and displays
any F
Electronic contro! has detected a fault condition. Press STOP!CLEAR
to clear the
code error (for exempme Fll)
display and stop beeping. Reprogram oven. If fault recurs, record fault number. Press
STOP/CLEAR
and calI 1=800-4=MY-HOME ® for assistance
(See back cover).
Oven light does not work.
Replace or tighten bulb. See Changing
Oven Light section in this Use & Care Guide.
Electrical power outage. Check house lights to be sure. CalI your local electric
compagny for service.
Surface burners
do not might,
Surface control knob has not been completely turned to LITE. Push in and turn the
surface control knob to MTE until burner ignites and then turn the surface control
knob to the desired flame size.
Burner ports are clogged. Clean burners. See "Cleaning
the Burner Grates, Burner
Caps and Burner Heads" under General Cleaning.
Range power is disconnected
from outlet. Be sure cord is securely plugged into the
outlet.
Electrical power outage.
Surface
burner flame burns haft way
around.
Be sure the gas supply to the range is turned "ON".
Burner ports or slots are clogged. With the burner off, use a small-gauge
wire or
needle to clean ports or slots.
Moisture is present after cleaning. Lightly fan the flame and allow the burner to
operate until flame is full= Dry the burners thoroughly
following instructions
under
General
Cleaning.
27

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido