Kenmore 790.3667 Serie Manual De Uso Y Cuidado página 25

Genera Care & CReaning (cont'd)
Removing and Replacing the E×ternal Door G_ass Pane_
AppHcaMe onUyto modeUs with an externaU gUass paneUnot heUdwith frame, This design allows you to dean the inside
face of the exterior door paneU as well as the hidden face of the door inner gUass,
To Remove the External Door Glass Paneh
1, Remove the door as described in Removing and Replacing the Oven Door section and Uaythe door fiat,
2, Using a screwdreiver, remove the 5 screws fastening the gUass& moUding assemMy,
3, Grasp both sides of the glass panel and slowly pull it out of the door upper molding, Lay the glass flat,
To Reptace the ExternaJ Door Glass Paneh
1, Grasp the sides of the glass panel carefully insert the glass into the door top molding,
2, Replace the 5 locking screws,
3, Replace the door onto the range,
Handle the glass panel with care, When dropped on a corner, the glass panel may shatter, This can
cause several persona injury,
Storage Drawer
Use the storage drawer for storing cooking utensils, The drawer can de removed to facilitate cleaning under the range, Use
care when handling the drawer, ...... .......
To open the storage drawer, push the drawer in gently and it will spring open, To close, push the drawer until you hear a [
click, which indicates that the spring is compressed, and the drawer is closed,
Roller
Roller
Guide
Front
Frame
Storage
Drawer
Removing and Replacing Storage Drawer
To remove the drawer:
1, Pull empty drawer out to the roller guide stop,
2, Tilt the drawer up and pull it out over the rollers,
To replace the drawer:
1, Insert the rear end of the drawer into the opening,
2, Fit the drawer end rollers onto the guide rails,
3, Push the drawer in until it stops, then lift to allow the rollers to clear the
roller guide stop, and push in,
25