Control Panel And Functions - Klarstein Vinsider 36 Built-in Duo Manual De Instrucciones

EN
26
Notes on temperature regulation
Please note that depending on the loading and settings chosen it takes about 24 hours
for the wine cooler to see the temperature stabilizing. During this time LED seems to
move erratically in particular,It is normal and this process occurs whenever the setting is
modified and/or whenever a large amount of bottles are added to the cooler.
Temperature settings
Note: The LED displays by default the actual internal air temperature. In the event of a
power interruption, all previous temperature settings are automatically erased and it
will revert to the preset temperature settings.
The electrical board of all models comes with memory function. It is important to
understand that there is a difference between the air temperature inside the wine cooler
and the actual temperature of the wine: You will need to wait approximately 12 hours
before noticing the effects of temperature adjustment due to the critical mass within a full
wine cooler.
Once the temperature is set, it is strongly advised not to toy with it or adjust frequently.
The thermostat will maintain the temperature inside the wine cooler within a +/- 2.5 °C
range. But the thermal inertia of the wine and the glass is such that within this
temperature range, the actual temperature of the wine will only fluctuate 0.5 °C to 1 °C.

CONTROL PANEL AND FUNCTIONS

Note: In lock mode, all buttons are disabled. Make sure to unlock them first.
ON/OFF
1. Press and hold the button for 3 seconds and it will power
2. Press and hold the button for another 3 seconds to switch the
down and go into standby mode.
appliance back on.