Battery Maintenance; Attention After Submersion; Corrosion Protection - Generac 7 kW PowerPact Manual Del Usuario

Battery Maintenance

The battery should be regularly inspected per the
Service Schedule:
1. With the generator shut down, lift the lid and
remove the front panel and the battery access
panel.
2. Inspect the battery posts and cables for tightness
and corrosion. Tighten and clean as necessary.
3. Check the battery fluid level of unsealed batteries,
and if necessary, fill with distilled water only. DO
NOT use tap water. Also, have the Independent
Authorized Service Dealer or a qualified Service
Technician check the state of charge and condition.
WARNING
Explosion. Do not dispose of batteries in a fire.
Batteries are explosive. Electrolyte solution can cause
burns and blindness. If electrolyte contacts skin or eyes,
flush with water and seek immediate medical attention.
WARNING
WARNING
Electrical shock. Disconnect battery ground
terminal before working on battery or battery
wires. Failure to do so could result in death
or serious injury.
WARNING
WARNING
Environmental Hazard. Always recycle batteries at an
official recycling center in accordance with all local
laws and regulations. Failure to do so could result in
environmental damage, death or serious injury.
Strictly observe the following precautions when working
on batteries:
•
Remove the 7.5 Amp fuse from the generator
control panel.
• Remove all jewelry—watches, rings, metal objects,
etc.
• Use tools with insulated handles.
Owner's Manual for 7 kW PowerPact™
• Wear rubber gloves and boots.
•
Do not place tools or metallic objects on top of the
battery.
• Disconnect the charging source prior to connecting
or disconnecting battery terminals.
• Wear full eye protection and protective clothing.
• Where electrolyte contacts the skin, wash it off
immediately with water.
• Where
thoroughly and immediately with water and seek
medical attention.
•
Wash down spilled electrolyte with an aid
neutralizing agent. A common practice is to use a
solution of 1 pound (500 grams) bicarbonate of
soda to 1 gallon (4 liters) of water. The bicarbonate
of soda solution is to be added until the evidence of
reaction (foaming) has ceased. The resulting liquid
is to be flushed with water and the area dried.
• DO NOT smoke when near the battery.
(000162)
•
DO NOT cause flame or spark in the battery area.
• Discharge static electricity from the body before
touching the battery by first touching a grounded
metal surface.
Always recycle batteries in accordance with local laws
and regulations. Contact your local solid waste collection
site or recycling facility to obtain information on local
(000137a)
recycling processes. For more information on battery
recycling, visit the Battery Council International website
at: http://batterycouncil.org/.

Attention After Submersion

If the generator has been submerged in water, it MUST
(000164)
NOT be started and operated. Following any submersion
in water, have an Independent Authorized Service Dealer
thoroughly clean, dry, and inspect the generator. If the
structure (home) has been flooded, it should be
inspected by a certified electrician to verify there won't be
any electrical problems during generator operation or
when utility power is returned.
(000138a)

Corrosion Protection

Periodically wash and wax the enclosure using
automotive type products. Do not spray the unit with a
hose or power washer. Use warm, soapy water and a soft
cloth. Frequent washing is recommended in salt water/
(000228)
coastal areas. Spray engine linkages with a light oil such
as WD-40
Section 4: Maintenance
electrolyte contacts
®
.
the eyes, flush
21