Tabla de contenido
Publicidad
3 Faucet Installation
Instalación Del Rociador
1. Thread the hose [D] through the pipe [O]
inserting first the small fitting [G].
2. Thread the hose through the body [M] of
the faucet also inserting first the small
fitting [G].
3. Push down the end of the pipe that has the
nut [N] onto the body of the faucet.
4. Hand tighten clockwise the nut [N] onto
the body of the faucet.
5. Hold with one hand the end of the hose
[D] that has the large fitting [P] and with
the other hand, hand tighten clockwise the
faucet head [Q] onto the fitting. Push hose
in so the head aligns properly with the
notches on the pipe.
6. Unscrew the retaining ring [H] from the
bottom of the faucet and ensure the
washer [A] and gasket [B] are also kept
with the ring [H].
7. Install the faucet through the hole on the
sink, by first threading the flexible hose [D]
through the hole, then place the base of
the faucet thru the hole. A second person
may be required to hold this in place until
the faucet installation is complete.
8. From underneath, slide the washer and
gasket [A+B] and then the retaining ring
[H] over the free end of the flexible hose
[D] and slide it up to the exposed threaded
section of the faucet [E].
9. Tighten the retaining ring [H] by hand until
it is snug. Using a wrench or pliers, tighten
the assembly. Do not over tighten. Gently
tighten the 2 screws on the retaining ring
[H].
10. Attach the free end [G] of the flexible hose
onto the faucet outlet [F] and hand tighten.
Then, using one wrench on the hexagonal
nut of the faucet outlet and another on the
hose nut, tighten the two ends together.
Tighting with just a single wrench may
deform the hose nut.
11. Install the counter-weight [C] on the flexible
hose [D] approximately 30 inches (76.2 cm)
down from the underside of the faucet.
O
3
4
N
2
M
76.2 cm
(30 in)
C
1
P
5
Q
J
K
L
E
B
A
H
F
G
D
Publicidad
Tabla de contenido
