Test Mode - Brightwell Brightstar II Manual De Instrucciones

T M
EST ODE
To access the TEST MODE, first de-power the unit.
Then, while holding down the
up.
When the unit has initiated, it will be in TEST MODE.
To check the keypad is functioning correctly:
Press each button in turn, and its function will appear on the
display, indicating that the key is working.
Each key will function as normal, if held down for two seconds.
To check the unit is functioning as desired:
TEST
Press and hold the
COUNT/SIGNAL screen will be displayed. The inputs can then
be triggered, and will display if a signal is present. If a signal is
present for more than one second, the pump will run for 2
seconds and the pulse counter will increment by one.
To disable the PUMP STOP mode:
When in TEST MODE, hold down the
seconds.
Input the security access code as normal.
The PUMP STOP - DISABLE screen will be shown.
From the PUMP STOP - DISABLE screen, Use the
keys to ENABLE or DISABLE the pump stop mode.
FWD/ACCEPT
Press the
move on to the PRIME - DISABLE screen.
To disable the PRIME mode:
From the PRIME - DISABLE screen, Use the
to ENABLE or DISABLE the prime mode.
FWD/ACCEPT
Press the
move on to the VIEW MODE - DISABLE screen.
To disable the VIEW mode:
From the VIEW MODE - DISABLE screen, Use the
keys to ENABLE or DISABLE the view mode.
FWD/ACCEPT
Press the
move back to the TEST MODE screen.
To exit the TEST MODE, de-power the unit, then power it back
up as normal.
B L S
RIGHTSTAR AUNDRY YSTEMS
-
( . D
INCL ISABLING
TEST
key, power the unit back
key for 2 seconds, and the PULSE
FWD/ACCEPT
key to confirm your selection and
UP/DOWN
key to confirm your selection and
key to confirm your selection and
P S & P
UMP TOP
00000 BSL10
TEST
MODE
ENTER ACCESS
CODE
----
00000 BSL10
TEST
MODE
key for 2
UP/DOWN
keys
UP/DOWN
44
)
RIME
01
01
B
RIGHTSTAR
E
NGLISH
L S
AUNDRY YSTEMS