Glossary - Brightwell Brightstar II Manual De Instrucciones

G
LOSSARY
Signal Acceptance
- Length of time that a signal must be present on an Input before it is acknowledged.
Flush Valve
- 24V DC output to control a Flush Solenoid (maximum 36W). This output is active throughout the
operation of any pump.
Delay Time
- Adjustable time period between a signal being acknowledged and a pump beginning its operation.
Speed -
Adjustable rotation rate at which each pump will operate.
Flowrate -
The speed at which product is dispensed from a pump. Specified in ml/min.
Run-Time
- Adjustable time period for which a pump will operate.
Dosage -
The volume of product which is required to be dosed into a wash cycle by each pump.
Pulse
- Signal number that a pump is to operate on. Pulse counter returns to zero when the unit resets.
Reset Delay
- Adjustable time period at the end of the wash cycle before the dispenser resets. The Reset Delay
begins after the operation of the final pump (ie: Pump 8, on an 8-Pump unit).
Relay -
Operational mode allowing the Pumps to run as if they were directly driven from the input signals.
Safety Stop -
Water sensor input to detect the presence of water within a Manifold.
Machine Interrupt -
Output to allow the interruption of a Laundry Machines cycle via the use of a relay.
Cycle Counters -
Provides a record of the number of cycles and length of time that has been completed by each
pump and program.
Prime -
Run the pump to fill the suction and delivery tubes.
Pump Stop -
Switch the pumps off in case of failure and to prevent operation during maintenance.
B L S
RIGHTSTAR AUNDRY YSTEMS
47
E
NGLISH
B L S
RIGHTSTAR AUNDRY YSTEMS