4. If necessary, ground the shield to the screw of the ground terminal
protective conductor connection.
①
Power supply isolator with installed load
resistor
②
Auxiliary power
③
Ground terminal
Figure 4-1
Schematic electrical connection
Closing the device
②⑤
1. Screw the covers
2. Secure each cover with the cover catch
①
3. Close the key cover
4. Tighten the screws in the key cover.
5. Check the tightness of the blanking plugs
SITRANS P500 with HART
A5E02344532-04, 12/2014
back on as far as they will go.
③
.
.
④
and cable gland
④
. This is electrically connected with the external
④
Connecting terminals
⑤
Protective conductor connector/equipotential bonding terminal
⑥
Cable entry for auxiliary power/analog output
⑥
in accordance with the degree of protection.
17