Deleting All User Codes; Opening The Door - G-U BKS Manual De Instrucciones

Operating instructions
Fingerprint scanner and code keypad

4.5 Deleting all user codes

With the in-wall or on-wall version, you can trigger a reset which restores the factory settings via the
inside unit by deleting all user codes. To do this, press the "Delete" button until the red LED lights up.
The device is subsequently in the delivery condition (red + green + blue LEDs light up continuously).
Attention! The master code is not changed when the factory settings are restored. If you have defined
a separate master code, this remains valid after the reset.
You can delete all user codes saved up till now by entering the following sequence at the code
keypad:
Enter the
＊
master code

4.6 Opening the door

Enter the
Press the
user code
access is successful, the
green LED lights up.
BKS GmbH, D-42502 Velbert
Phone +49 2051 201-0
Fax +49 2051 201-431
www.g-u.com
Operating instructions, edition 3 dated 03/01/2013
Copyright © G-U GmbH, 2012. All rights reserved.
0
＊
button. If
Note
We reserve the right to change the contents of this document without prior notice.
Gretsch-Unitas GmbH Baubeschläge will not accept liability for technical or editorial errors
or omissions in this document. Moreover, Gretsch-Unitas GmbH Baubeschläge will not
assume liability for damage arising directly or indirectly from the delivery, performance or
use of this material.
This document is protected by copyright and must not be copied or reproduced in whole or
in part in any manner or form without the written approval of Gretsch-Unitas GmbH
Baubeschläge.
Enter the
＊
master code
again
C 59 501 106
＊
Page 50