Operation On A Pabx; Enter/Delete An External Line Prefix; Using The Flash Key (On A Pabx) - Gigaset 5040 Guia De Inicio Rapido

Changing the number to be dialed
In order to use outgoing number formats which are not
covered by the automatic format assignment, you can
manually switch the number format when dialing from
the Calls list.
By default the number is stored and dialed in a 10-digit
format, e.g.: 8881234567
The following other formats are possible:
18881234567
1 is inserted as 1st digit
1234567
Only the last 7 digits are dialed
To change the number to be dialed from the Calls list:
.
Press the Calls list key.
H I
... Scroll to the desired number you want to
dial.
*
Press the star key to switch between the
number formats.
12
en

Operation on a PABX

Enter/delete an external line prefix

If you are using your telephone on a PABX, you may have
to save one or more external line prefixes. A dialing
pause is set automatically with the external line prefix.
You can save up to three external line prefixes.
º0
Hold down the Set key, then press the 0 key,
If no external line prefix has been set in a
location, z appears in the display.
If several external line prefixes are saved,
these are displayed next to one another; the
external line prefix to be edited flashes.
If necessary, use the
between the external line prefixes dis-
played, to edit them as follows:
º
To delete an external line prefix:
Hold down the Set key.
o
To enter an external line prefix:
Enter a one- to three-digit code.
; o
Enter additional external line prefixes:
Press the Redial key, enter next external line
º
prefix.
Hold down the Set key.

Using the Flash key (on a PABX)

During an external call, you can redial the last number,
or divert the call. To do this, press the Flash key
The subsequent procedure depends on your PABX. By
default, the Flash key is preset to a flash time (interrup-
tion time) of 90 ms for use of new features on standard
telephone systems. With a connection to a PABX, it may
be necessary to change the flash time (e.g. 600 ms). For
how to do this, please refer to the operating instructions
for your PABX.
To use services that are to be triggered with the Flash
key, make sure beforehand that the correct flash time is
set for the key (see page 10).
;
key to toggle
º
.