SMA PLA Option FLX Serie Guia De Instalacion página 8

Installation
WARNING
Do not add a power source to the option. Adding a
power source above 20 V to the relay damages the
option module.
1.3 Closure and Verification
1. Close the cover of the inverter installation area.
Ensure that the cover is correctly fastened.
2. Turn on PV and AC connection.
3. Verify that the option is detected. Refer to
2.1.5 Verification.
1.4 Removal
To remove the option:
1. Insert a screwdriver at the snap connector on the
side of the option.
2. Apply pressure sideways to release the snap
connector as shown in Illustration 1.6.
3. Lift the option off the option slot.
Illustration 1.6 Removal of Option
L00410649-02_2q / Rev. date: 2014-06-20
1 1
7