Peavey GPS Serie Guía De Operación página 18

Rated Power (2 x 2 ohms):
Rated Power (2 x 4 ohms):
Rated Power (2 x 8 ohms):
Rated Power (1 x 2 ohms):
Rated Power (1 x 4 ohms):
Rated Power (1 x 8 ohms):
T.H.D. (2 x 2 ohms):
T.H.D. (2 x 4 ohms):
T.H.D. (2 x 8 ohms):
Input CMRR:
Voltage Gain:
Crosstalk:
Hum and Noise:
Power Consumption:
Slew Rate:
Damping Factor (8 ohms):
SMPTE IMD:
Input Sensitivity (x 40):
Input Impedance:
Current Draw @ 1/8 rated
power @ 2 ohms:
Cooling:
Controls:
Indicator LEDs:
Protection:
Connectors:
Construction:
Dimensions:
Weight:
GPS 3400 SPECIFICATIONS
1,700 watts @ 1 kHz both channels driven at <0.15% T.H.D.
1,200 watts @ 1 kHz both channels driven at <0.1% T.H.D.
750 watts @ 1 kHz both channels driven at <0.1% T.H.D.
1,800 watts @ 1 kHz at <0.1% T.H.D
1,350 watts @ 1 kHz at <0.1% T.H.D
825 watts @ 1 kHz at <0.05% T.H.D
<0.15% @ 1350W from 20 Hz to 20 kHz with both channels driven
<0.1% @ 1000W from 20 Hz to 20 kHz with both channels driven
<0.08% @ 700W from 20 Hz to 20 kHz with both channels driven
> - 65 dB @ 1 kHz
x 40 (32 dB)
> -75 dB @ 1 kHz at rated power @ 8 ohms
> -115 dB, "A" weighted referenced to rated power @ 8 ohms
> 1400 watts
> 40V/us
> 325:1 @ 20 Hz - 1 kHz
<0.1% 60Hz and 7 kHz, 950W @ 4 ohms
1.7 volts for 4 ohm rated power, 1.4 volts for 2 ohm rated power
20 k ohms, balanced
11.66 A @ 120 volts
Two 80 mm DC fans, off until heatsinks reach 45
Two front panel attenuators
Two DDT/Clip, 2 Signal, 2 Power
Thermal, DC, turn-on bursts, subsonic, incorrect loads
XLR input, 6.3mm phone type output patch, Speakon and Binding Post speaker output, IEC mains input
16 ga. steel reinforced with 12 ga.rack ears
133 mm x 483 mm x 432 mm, 400 mm behind rear mounting ears (5.23" x 19" x 17", 15.75" behind rack ears)
49.8 lbs. (23.3 kg)
Specifications subject to change without notice.
0
C, then temperature dependent variable speed
18