Troubleshooting - Philips FC8820 Manual Del Usaurio

Troubleshooting

Problem
The robot does not start
cleaning when I press the
start/stop button.
The warning indicator
flashes quickly.
This chapter summarizes the most common problems you could encounter
with the machine. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Center in your country.
Possible cause
The rechargeable battery is
empty.
The small plug is still inserted
in the socket on the robot.
The power switch is not set to
'on' I position.
One or both wheels are stuck. Set the power switch to 'off'. Remove the
One or both side brushes are
stuck.
The top cover is not present
or is not closed properly.
The bumper is stuck.
The robot was lifted while it
was cleaning.
Solution
Charge the rechargeable battery see
chapter 'Preparing for use' .
The robot does not work on mains power.
It only works on its rechargeable battery.
Therefore, always disconnect the adapter
from the robot and the mains before use.
Press the power switch. Press the
start/stop button on the robot or on the
remote control to start cleaning.
fluff, hair, thread or wire that is caught
around the wheel suspension.
Clean the side brushes see chapter
'Cleaning and maintenance' .
When the top cover is not present or is not
closed properly, the robot does not work.
Place the top cover on the robot properly.
Press the start/stop button. Lift the robot
so that its bumper comes free. Place the
robot at some distance from the obstacle
and press the start/stop button to make it
resume cleaning.
Press the start/stop button. Place the
robot on the floor. Then press the
start/stop button to make the robot
resume cleaning.
English