Navigating The Robot With The Pointer - Philips FC8820 Manual Del Usaurio

English
50-70 cm
Using the virtual wall unit FC88
2
1

Navigating the robot with the pointer

- When you press and hold the pointer button, the pointer emits a beam of
infrared light. With this beam you can drag the robot in a particular
direction. As long as you keep the button pressed and keep pointing in
the direction you want the robot to move, it continues to move in that
direction. When you release the pointer button, the robot starts cleaning
in auto cleaning mode.
- With the pointer you can send the robot to a specific area in the room to
give this area an extra-thorough clean.
Placing the batteries in the invisible wall
The invisible wall operates on four AA batteries.
Push the two release tabs at the bottom of the back cover
the back cover upwards and off the invisible wall
Take four new AA batteries from the pack and insert them into the
battery compartment of the invisible wall.
Note: Make sure the + and - poles of the batteries point in the right
direction.
and slide
.