V2 PROG2-USB Manual De Instrucciones página 19

1. ROYAL PLUS TRANSMITTER MENU
The screen must display:
ROYAL PLUS
TX MENU
Press ENTER key, the screen displays:
READING TX PLUS
CODIFIED
Now pressing keys , it is possible to select the following
menus:
READING OF CODIFIED PLUS TX: it permits to self learn a
ROYAL PLUS transmitter code and display the transmitter
features through the insertion into the appropriate TX
connector or by radio.
READING OF PLUS TX WITH SWITCHES: it permits to display
the ROYAL PLUS transmitter dip-switches code and edit it.
READING OF CODIFIED PLUS TX
This menu is divided into other two submenus:
• READING TX PLUS FROM RADIO: it permits to display the
dip-switches code of the corresponding key of the Royal Plus
transmitter.
• READING TX PLUS FROM CONNECTOR: it permits to display
the transmitter features and create a duplicate of it.
READING OF PLUS TX BY RADIO
To display the dip-switches code of each key of ROYAL PLUS TX
go on as follows. The screen must display:
READING TX PLUS FROM
RADIO
Press ENTER, the screen displays:
PLUS TRANSMITER
Transmit using the appropriate key, the screen displays: (Example)
READING OF PLUS TX BY CONNECTOR
To display ROYAL PLUS TX in question features and duplicate its
content, go on as follows. The screen must display:
READING TX PLUS FROM
CONNECTOR
Press ENTER, the screen displays:
INSERT TX PLUS
SOURCE
Insert PLUS TX into the TX connector and press ENTER, the screen
displays: (Example 1)
CODE TX TSS
NO-LIM QUAD 32MS
CODE TSS TX: it shows that the transmitter in question is a TSS
(code 53200).
NO-LIM: it shows that it is a no-limit transmission.
TSS
15
QUAD: it shows it is a four-way channel.
32MS: it shows that the code length is 32ms (this parameter is
not shown if it is a TSR-4).
(Example 2)
CODE TX TSR
TR-LIM BIC
TSR TX CODE: it shows that the transmitter in question is a TSR
(ROYAL code).
TR-LIM: it shows that it is a limit transmission (3 sec.).
BIC: it shows it is a two-way channel.
Now to duplicate the ROYAL PLUS TX in question, insert another
TSR or TSS, depending on the cases, into the TX connector and
press PROG-TX button. If the programming is correct, PROG2
sends one sound impulse and displays:
TX ROYAL PLUS
CODIFIED
In case of error, PROG2 sends two sound impulses and displays
an error message (see ERROR MESSAGES paragraph).
READING OF PLUS TX WITH SWITCHES
This menu permits to display and edit as you want the dip-
switches code of each single key of a ROYAL PLUS (TSR or TSS)
transmitter.
Insert a ROYAL PLUS TX into the TX connector and go on as
follows. The screen must display:
READING PLUS TX
WITH SWITCHES
Press ENTER, the screen displays: (example)
The first dip switch flashes: pressing the key ENTER the dip-switch
position changes; select the desired position.
Through keys , select the dip-switches to edit, then press
PROG-TX key to store the updated codification of key 1.
TX ROYAL PLUS
CODIFIED
Press ENTER key to go on with the other keys programming.
Through keys 1,2,3,4 select the desired key (displayed below on
the right), personalise the codification and store, pressing PROG-
TX at every key.
After the programming, press ESC to go back to the initial menu.
TSS
1