V2 PROG2-USB Manual De Instrucciones página 20

2. PERSONAL PASS
TRANSMITTER MENU
The screen must display:
PERSONAL PASS
TX MENU
Press ENTER key, the screen displays:
READING TX PASS
CODIFIED
Pressing ESC key, you go back to the previous menu.
Now pressing keys , it is possible to select the following
menus:
• READING OF CODIFIED PASS TX: it permits to self learn a
Personal Pass transmitter code by radio or insertion into the
appropriate TX connector.
• CODIFICATION OF TX WITH LABEL CODE: it permits to type
by keyboard the label code.
• CODIFICATION OF TX WITH RANDOM CODE: it permits to
generate at random and automatically a label code.
READING OF CODIFIED PASS TX
This menu permits to display the label code of a PERSONAL PASS
transmitter.
It is possible to use this function in two different ways.
• READING BY RADIO TRANSMISSION
• READING BY CONNECTOR
READING BY RADIO TRANSMISSION
PROG2 is equipped with an inside modular receiver, that permits
to learn by radio the transmitted code. The screen must display:
READING TX PASS
CODIFIED
Press ENTER key, the screen displays:
READING TX PASS
FROM RADIO
Press ENTER key, the screen displays:
PASS TRANSMITER
Press the key of the desired transmitter. PROG2 signals the
correct code learning, sending one sound impulse. The screen
displays the learnt code: (example)
CODE TX
BGXX051
If it does not learn the code correctly, PROG2 sends two sound
impulses and displays an error message (see ERROR MESSAGES
paragraph).
To duplicate the learnt code, see DUPLICATION paragraph.
If the PROG2 receives a code of a SUBSTITUTIVE TRANSMITTER,
the display will show: (example)
CODE TX
/RJT271(2)
The digit in parenthesis shows the level of the SUBSTITUTIVE
TRANSMITTER. Each code can be substituted no more than three
times, therefore the levels can be 1,2,3. The substitutive
transmitter can be created only by WINPPCL and it is not possible
to duplicate it by means of PROG2.
READING BY CONNECTOR
It is possible to read a code, inserting the transmitter into the
appropriate outside TX connector. To be able to learn the code
with this modality, it is necessary to open the transmitter, take
the card out and then insert it correctly into the TX connector.
The screen must display:
READING TX PASS
CODIFIED
Press ENTER key, the screen displays:
READING TX PASS
FROM RADIO
Press key , the screen displays:
READING TX PASS
FROM CONNECTOR
Insert the transmitter card into the TX connector of PROG2. Press
ENTER key: PROG2 signals the correct code learning, sending one
sound impulse. The screen displays: (example)
CODE TX
25YK760
If it does not learn the code correctly , PROG2 sends two sound
impulses and displays an error message (see ERROR MESSAGES
paragraph).
To duplicate the learnt code, see DUPLICATION paragraph.
CODIFICATION OF TX WITH LABEL CODE
This function permits to type directly by keyboard the label code
you want to display for a possible duplication.
Note: The label code of a Personal Pass transmitter is a seven-
figure code (the seventh digit can be only 0,1,2,3; the number 3
will appear only if PROG2 receives by radio the code of a TMU99
transmitter, that can not be programmed by means of PROG2).
The screen must display:
READING TX PASS
CODIFIED
Press key , the screen displays:
TX CODE WITH
LABEL CODE
Press ENTER key, the screen displays:
INSERT CODE
#######
16