V2 PROG2-USB Manual De Instrucciones página 21

Now it is necessary to type on the keyboard the desired label
code: each one of the key that permits to write a numeric,
permits also to write three alphanumerics: just press more times
the same key to write the desired letter.
For example, key 2 permits to write four characters:
"2" pressing the key once.
"A" pressing the key twice.
"B" pressing the key three times.
"C" pressing the key four times.
If you keep the key pressed, you perform the continuous scroll of
the four
characters. The pointer is positioned under the first number, then
type the desired numeric or alphanumeric.
Press key to move the pointer ( _ ) under the following
number and insert the new character.
Type the six number of the desired label code. Press ENTER key to
confirm. The screen displays:(example)
CODE TX
AX13JK1
If the typed code is not correct, PROG2 sends two sound
impulses and displays an error message (see ERROR MESSAGES
paragraph).
To duplicate the typed code, see DUPLICATION paragraph.
CODIFICATION OF TX WITH RANDOM CODE
This menu permits to generate at random and automatically a
label code for a possible duplication.
The screen must displays:
READING TX PASS
CODIFIED
Press more times key until the screen displays:
TX CODE WITH
RANDOM CODE
Press ENTER key: when the key is pressed, PROG2 generates a
random series of label codes.
When the key is released, the screen displays the last generated
code (example):
CODE TX
25YJ9K0
To duplicate the code, see DUPLICATION paragraph.
DUPLICATION
It is possible to gain access to the function, after the code
learning in the following ways: by radio transmission, connector,
typing directly by keyboard or generation of a random code. The
code learnt in such a way can be duplicated inside a VIRGIN
transmitter of the Personal Pass series. For a successful
duplication, it is necessary to read carefully the following
instructions.
The screen must display the desired code: (example)
CODE TX
25YJ9K0
Press PROG-TX key, PROG2 sends two sound impulses and
displays:
INSERT TX PASS
TARGET
Open the container of the TX to programme, then take the card
out and insert it correctly into the TX outside connector.
Press ENTER key to duplicate it.
In case of error, PROG2 sends two sound impulses and displays
an error message (see ERROR MESSAGES paragraph). PROG2
signals the correct code learning, sending one sound impulse and
the screen displays:
TX PERSONAL PASS
CODIFICATO
Press any key to go back to the previous menu.
17