Error Messages - V2 PROG2-USB Manual De Instrucciones

RX PASSWORD
This menu allows to enter a four-digit PASSWORD on the
receiver. This password will be requested by PROG2 during all
accessing operations.
This function is enabled only for the receivers of the group B.
The display shows:
CODIFICA ZONA
RX
Press more times the push button
PASSWORD
RX
Press ENTER; the display will show:
PASSWORD
:
Enter the four-digit PASSWORD you want to store and confirm it
after ":" (colon) :
If the PASSWORD has been settled correctly the display will show:
PASSWORD
OK
The PASSWORD has been selected and it will be requested each
time you try to modify the receiver. It will be not requested when
you are programming receivers with the same PASSWORD.
To erase the selected PASSWORD, select the PASSWORD menu;
the display will show:
PASSWORD?
Enter the PASSWORD and press ENTER. The display will show:
PASSWORD
:
Type 0000 and repeat these digits after ":" (colon).
Press ENTER, the display will show:
PASSWORD
OK
The PASSWORD has been disabled.

ERROR MESSAGES

TX ERROR
INVALID TARGET
ROYAL PLUS transmitter to duplicate inserted into the outside
connector is different from the source TX. For example source TX
is a TSS, while the target transmitter is a TSR, or vice versa.
TX ERROR
NO ACCESS
The transmitter to duplicate inserted into the outside connector
contains a different customer code, or the code received by
PROG2 (by radio, keyboard or connector) contains a different
customer code or was received not correctly.
until the display will show:
TX ERROR
PASSE-PARTOUT
The code received by PROG2 (by radio, keyboard or connector
belongs to a PPS transmitter), or the target transmitter inserted
into the outside connector is a PPS model.
TX ERROR
TX-KEY
The code received by PROG2 (by radio, keyboard or connector
belongs to a PPS transmitter), or the target transmitter inserted
into the outside connector is a TX-KEY model.
TX ERROR
FAILURE
The transmitter to duplicate inserted into the outside connector is
damaged.
TX ERROR
BLANK
The code received by PROG2 is the code of a TXP programmable
transmitter.
TX ERROR
FULL
The target TXP transmitter, inserted into the connector was
previously codified, or it is a transmitter of the PERSONAL PASS
series.
MEM ERROR
PRESENT CODE
The code received by PROG2 is already in memory, precisely in
the memory zone shown in brackets.
MEM ERROR (SSX)
PRESENT CODE
The code received from PROG2 is already stored and it is a
SUBSTITUTIVE TRANSMITTER.
MEM ERROR
FAILURE
The memory module inserted into the connector is damaged.
MEM ERROR
INCOMPATIBLE
The memory module inserted into the TARGET connector has a
capacity lower than the module inserted into the SOURCE
connector.
To exit from the error condition, press any key, the screen
displays the main MENU.
24