V2 PROG2-USB Manual De Instrucciones página 24

B. Modification of a memory zone set ups
The screen must display: (Example)
168 V2 IBERICA
3 KS*FGX1 2 BIST.
Press more times ENTER key, the pointer moves showing the
current selection.
IMPORTANT: it is not allowed to replace the key number with a
memory one: as a matter of fact during the selection, the screen
displays only the enabled keys or the keys that are not stored.
After the modifications, press ENTER key until you see on the
screen:
DO YOU CONFIRM?
ESC=NO
Pressing ESC key, PROG2 displays previous data and does not exit
from the programming.
Pressing ENTER key, PROG2 exits from the programming and save
in memory performed modifications.
MEMORY MODULE DUPLICATION
This menu permits to transfer in block all data of a memory
module into another module:
IT IS INDISPENSABLE THAT THE TARGET MEMORY MODULE HAS
THE SAME OR HIGHER CAPACITY THAN THE SOURCE MODULE
(it is possible to transfer data from MEM200 to MEM200-I and
from MEM1000 to MEM1000-I, but not viceversa).
The screen must display:
MEM MODULE
ZONE CODIFIER
Press key , the screen displays
MEM MODULE
DUPLICATION
Pressing ESC key, you go back to the previous menu.
Press ENTER key, the screen displays:
INSERT MEM
SOURCE
IInsert the module you want to copy into the MEM SOURCE
connector. Press ENTER key, the screen displays:
INSERT MEM
TARGET
Insert into the MEM TARGET connector, the initialised target
memory module. Press ENTER key, the screen displays:
MEM S
PROG2 transfers data from MEM SOURCE to MEM TARGET.
If the duplication is successful, the screen displays:
MEM MODULE
CODIFIED
If the duplication is not successful, the screen displays an error
message (see ERROR MESSAGES paragraph).
*
ENTER=YES
. .
MEM T
MEMORY MODULE COMPLETE DELETION
This menu permits to delete all memory zones codes with their
set ups. After this operation, memory module is virgin again and
can be completely reused.
The screen must display:
MEM MODULE
ZONE CODIFIER
Press more times key
MEM MODULE
TOTAL ERASURE
Press ENTER key, PROG2 sends two sound impulses, the screen
displays:
INSERT MEM
SOURCE
Insert the module you want to delete into the MEM SOURCE
connector. Press ENTER key, the screen displays
DO YOU CONFIRM?
ESC=NO
Pressing ESC key, you cancel the operation and the screen
displays:
MEM MODULE
TOTAL ERASURE
Pressing ENTER key, PROG2 deletes completely the memory
module. The screen displays:
ERASURE INTO
EXECUTION
If the deletion of a memory module is correct, PROG2 sends one
sound impulse and the screen displays:
MEM EMPTY
Press any key, the screen displays the main menu.
If the deletion is not correct, the screen displays an error message
(see ERROR MESSAGES paragraph).
PASSE-PARTOUT YES / NO
This menu permits to enable and disable Passe-Partout function
on the receiver.
If the function is enabled, the installer can use a PPS transmitter
to gain access to the system. Each key of that transmitter enables
the exit that corresponds to the pressed key number only in
monostable logic. (Example: key 1 enables relay exit 1 in
monostable logic, key 2 enables relay exit 2 in monostable logic
etc...).
The screen must display:
MEM MODULE
ZONE CODIFIER
Press more times key
PASSE-PARTOUT
YES / NO
20
until the screen displays:
ENTER=YES
until the screen displays: