Press ENTER key, PROG2 sends two sound impulses, the screen
displays:
INSERT MEM
SOURCE
Insert the receiver you want to programme into the TX
connector.
Press ENTER key, PROG2 sends one sound impulse, the screen
displays:
PASSE-PARTOUT
NO
if the function was disabled or
PASSE-PARTOUT
YES
if the function was enabled.
Press one of the keys
(YES / NO). Press ENTER, the screen displays
DO YOU CONFIRM?
ESC=NO
Pressing ESC key, you cancel the operation.
Pressing ENTER key, PROG2 displays:
PASSE-PARTOUT
YES / NO
Press ESC to go back to the main menu.
4. RECEIVER CODIFIER MENU
To gain access to RECEIVER CODIFICATION menu functions, read
carefully the following instructions. The screen must display:
RX
CODIFIER MENU
Press ENTER key, the screen displays:
RX
ZONE CODIFICATION
Now, pressing keys
it is possible to select the following
menus:
RX ZONE CODIFICATION: It permits to display the receiver
memory zones and edit their content using the keyboard, delete
desired zones, store a code by radio transmission or keyboard,
store by radio a high number of codes in sequential learning.
RX DUPLICATION: It permits to duplicate the whole content of a
receiver memory (RXP-1/50S, RXP-2/50S) inside another receiver
of the same model.
RX COMPLETE DELETION: It permits to delete the whole
memory content of a receiver module.
PASSE PARTOUT (YES / NO): It permits to enable or disable
passe-partout function on the receiver.
PASSWORD: it permits to enable or disable PASSWORD function
on the receiver.
to change current selection set up
ENTER=YES
RX ZONE CODIFICATION
This menu permits to monitor each memory zone available on the
receiver. This feature permits to see the codes of the memory
module and also permits to the user to insert sequentially all the
desired telecontrols, delete single memory zones, edit the content
and the set ups of each single zone.
To codify the desired receiver module, read the following
instructions: the screen must display:
RX
ZONE CODIFIER
Press ENTER key, PROG2 sends two sound impulses and the
screen displays:
INSERT RX
SOURCE
Insert the receiver (initialised and not fed) you want to edit into
the TX connector. Press ENTER key, the screen displays the
memory zone 000 and the receiver model: (example)
000 RX2
1 PDH30Y1 3 T.210
FREE MEMORY ZONE PROGRAMMING
This function permits to programme one or more free memory
zones, inserting the desired codes and then setting up desired
functions.
You can store the desired code both by radio transmission and
keyboard.
To programme a free memory zone on the receiver, it is
necessary to read carefully the following instructions.
Select the desired free zone in one of the two following ways:
• Press one the keys
memory zone; keep the key pressed to scroll them quickly.
• Type directly by keyboard the desired zone number.
The screen must display the selected free zone: (Example)
025 RX2
0 ####### 0 MONO
Press ENTER key, the screen displays
PASS TRANSMITER
Now it is possible to go on in two different ways:
1) Learning by radio transmission: Press the desired
transmitter key, PROG2 stores automatically the label code and
pressed key number.
2) Insertion by keyboard: Press the PROG TX push button; the
display will show: (Example)
INSERT CODE
#######
• Type the characters of the label code.
• Press ENTER key to confirm the typed code, PROG2 assign
automatically the first free key, if there are not any enabled
keys, the screen displays an error message.
21
*
to scroll back or forward the