V2 PROG2-USB Manual De Instrucciones página 27

Insert into the outside TX connector the receiver you want to
duplicate. Press ENTER key, the screen displays:
RX
After the data learning, the screen displays:
INSERT RX
TARGET
Insert into the outside TX connector, the target receiver. TARGET
RECEIVER MUST BE ALREADY INITIALISED WITH THE
APPROPRIATE CONTRACT. Just store a transmitter of the desired
contract before going on with the programming.
Press ENTER key, the screen displays:
RX2
If the duplication is correct, the screen displays:
RX
CODIFIED
If the duplication is not correct, the screen displays an error
message (see ERROR MESSAGES paragraph).
RX TOTAL ERASURE
This menu permits to delete all receiver codes and their set ups.
After this operation, the module is virgin again and ready to store
new codes.
The screen must display:
RX
ZONE CODIFIER
Press more times key until the screen displays:
RX
TOTAL ERASURE
Press ENTER key, PROG2 sends two sound impulses, the screen
displays:
INSERT RX
SOURCE
Insert the receiver you want to delete into TX connector.
Press ENTER key, the screen displays:
DO YOU CONFIRM?
ESC=NO
Pressing ESC key you cancel the operation.
Pressing ENTER key, PROG2 deletes completely the receiver
module. The screen displays
ERASURE INTO
EXECUTION
If the deletion of the receiver memory is correct, PROG2 sends
one sound impulse and the screen displays:
MEM EMPTY
Press any key, the screen displays the main menu.
If the deletion is not correct, the screen displays an error message
(see ERROR MESSAGES paragraph).
PROG2
PROG2
ENTER=YES
PASSE-PARTOUT YES / NO
This menu permits to enable or disable Passe-Partout function on
the receiver.
If the function is enabled, the installer can use a PPS transmitter
to gain access to the system. Each key of that transmitter enables
the exit corresponding to the pressed key number only in
monostable logic. (Example: key 1 enables the relay exit 1 in
monostable logic, key 2 enables the relay exit 2 in monostable
logic etc...)
The screen must display:
RX
ZONE CODIFIER
Press more times key
PASSE-PARTOUT
YES / NO
Press ENTER key, PROG2 sends two sound impulses, the screen
displays:
INSERT RX
SOURCE
Insert the receiver you want to programme into the TX
connector.
Press ENTER key, PROG2 sends one sound impulse, the screen
displays:
PASSE-PARTOUT
NO
if the function was disabled or
PASSE-PARTOUT
YES
if the function was enabled.
Press one of the keys
selection (YES / NO). Press ENTER, the screen displays
DO YOU CONFIRM?
ESC=NO
Pressing ESC key, you cancel the operation.
Pressing ENTER key, PROG2 displays:
PASSE-PARTOUT
YES / NO
Press ESC to go back to the main menu.
23
until the screen displays:
to change the set up of current
ENTER=YES