Mounting The Scroll Saw To Plywood; Attaching Scroll Saw To Leg Set - Dremel 1680 Manual Del Usuario

Mounting the Scroll Saw
FIG. 15
Mounting the Scroll Saw to
"
24
Plywood
"
5/16 Dia.
An alternative method of securing your Scroll Saw is to
fasten the Scroll Saw base to a mounting board 18" x 24".
Any good grade of plywood with a 3/4" minimum thick-
ness is recommended. Follow the instructions for
"Mounting the Scroll Saw to a Bench", substituting the 18"
"
6 1/4
"
18
x 24" board for the workbench and using 1/4"-20 Flat
Head Screws for the Hex Screws (Fig.15).
"
16 3/4
Note: For proper stability, holes must be counter sunk so
screw heads are flush with the bottom surface of the sup-
porting board.
Securely clamp board to workbench using two or more
"C" Clamps.
FIG. 16
Attaching the Scroll Saw to
Leg Set
(Available as Accessory)
If you prefer to mount your Scroll Saw to a leg set we rec-
ommend the leg set for benchtop tools which is available
through Dremel. The model number is 16500. This leg set
is an optional accessory and instructions to mount the
Scroll Saw to this leg set are included in the package (Fig.
16).
16.