Unpacking And Checking Contents; Table Of Loose Parts; Tools Needed - Dremel 1680 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Unpacking and Checking Contents

To avoid injury from unexpected starting or
WARNING
!
electrical shock, always remove plug from
power source when tool is not in use.
Model 1680 Motorized Scroll Saw is shipped complete in
one carton.
1. Unpacking and Checking Contents. Separate all "loose
parts" from packing materials and check each item with
the "Table of Loose Parts" to make sure all items are
accounted for before discarding any packing material.
If any parts are missing, do not attempt to
WARNING
!
operate Scroll Saw, plug in the power
cord or turn the switch on until the missing parts are
obtained and are installed correctly.
PHILLIPS SCREWDRIVER
WRENCHES
7/16 in.
A

Tools Needed

COMBINATION
SQUARE

Table of Loose Parts

Item
Description
A
16" Scroll Saw ..........................................................1
B
Owner's Manual ........................................................1
C
Loose Parts Bag (containing)....................................1
Allen Wrench (3 mm) ................................................1
Allen Wrench (5 mm) ................................................1
Blades ....................................................................11
NOTE: Hardware to mount this Scroll Saw to a bench or
leg set is NOT supplied. See mounting instructions on
Page 15-16 for recommended hardware size.
To remove protective coating from the table surface,
moisten a soft cloth with kerosene and wipe off coating.
Do not use acetone, gasoline or lacquer thinner for this
purpose.
After removing protective coating, If you wish, you may
apply a coat of paste wax to the table to allow the work-
piece to slide easily across the table surface and deter
rust. Wipe the table thoroughly with a clean dry cloth.
B
COMBINATION SQUARE MUST BE TRUE
Check its accuracy as illustrated below.
DRAW LIGHT LINE
ON BOARD ALONG
THIS EDGE
SHOULD BE NO GAP OR OVERLAP WHEN
SQUARE IS FLIPPED OVER IN DOTTED POSITION
7.
Qty.
C
STRAIGHT EDGE OF
BOARD 3/4" THICK-
THIS EDGE MUST BE
PERFECTLY STRAIGHT

Publicidad

Tabla de contenido
loading

Tabla de contenido