Fiac AB598 Normas Generales Para La Instalacion, Uso Y Mantenimiento página 31

4. Preparing to use the multipurpose service unit
In order to use the compressor in complete safety read the safety standards before reading this section.
◊ 4.1 Operational principle
The multipurpose service unit allows the production of compressed air and single and three-phase alternating current
through the combined work of a two-stage lubricated piston pump unit and a power generator connected by belt to the
diesel engine combustion.
The application range of this multipurpose service unit includes use in a mobile workshops and maintenance equipped
vehicles.
◊ 4.2 Motor
Note!: The information in this manual are intendet to assist the operator during use and maintenance operation of the
compressor.
Please carefully read motor instruction manual before performing any operation.
Take care to transport the compressor correctly, do not overturn it or lift it with hooks or ropes.
4.2.1 General terms of use
Do not allow the engine or muffler to come in contact with flammable vapors, combustible dust, gases or other
combustible materials. A spark may cause a fire. Do not place this compressor in an area where flammable gas
vapors may be present.
Read the engine manual accompanying this compressor for correct engine start-up maintenance procedures.
Read and understand the safety labels located on this compressor.
Fuel recommended is Diesel. Do not mix with oil.
Check the engine oil level before starting (See engine manual).
Fill the fuel tank according to the engine manual instructions.
At least weekly check for leaks from the fuel tank.
4.2.2 Refueling
WARNING!
Follow all fueling instructions in operator's manual.
• Gasoline is extremely flammable, and gasoline vapor can explode.
• Do not refuel fuel tank while this compressor is running or hot.
• Never smoke near gasoline, and keep other flames and sparks away.
• Allow this compressor and engine to cool down before refueling.
• Do not refuel indoors or in a poorly ventilated area.
• Do not fill fuel tank to point of overflowing.
• Always refuel slowly to avoid the possibility of spilled fuel which may cause a fire.
• Do not operate this compressor if gasoline is spilled.
• Wipe this compressor clean and move it away from the spill.
• Avoid creating any ignition until the gasoline has evaporated.
• Allow approximately 1/4" of tank space for fuel expansion. Always store fuel away from this compressor while it
is running or hot.
• Always store gasoline in an approved container.
Fuel tank is located on the upper part of the motor, as shown on picture.
11
EN
EN