General Safety Warnings - Fiac AB598 Normas Generales Para La Instalacion, Uso Y Mantenimiento

◊ 4.6 Functioning
This compressor operate automatically.
The pilot valve control the tank load status, putting in idle running the compressor in case of tank full charge (max pres-
sure reached) and restarts it in case of air consumption (pressure drop).
WARNING!
IN CASE OF UNUSUAL NOISE OR VIBRATION STOPS THE COMPRESSOR IMMEDIATELY!
WARNING!
Always wear ears protection. Some work conditions and prolonged exposure to noise may cause hearing
loss and deseases.
Sound level measured in a free range at a distance of 4 m: ±3dB(A) at the maximum working pressure.
MOD.
598/678
The level of acoustic pressure can increase from 1 to 10 Db(A) according to the place where it is installed.
◊ 4.7 General safety warnings
This compressor is not intended for outdoor use or open environment.
The head/cylinder/delivery tube unit can reach high temperatures. Take care when working near these
parts, and do not touch them to avoid possible burns
Do not disconnect any part when the tank is pressurized. Discharge the pressure tank before any
maintenance.
- Do not drill holes, weld or purposely deform the compressed air tank.
- Do not do any jobs on the compressor unless it is off.
- Temperature in operating ambient: 0°C +35°C.
- Do not aim jets of water or inflammable liquids on the compressor.
- Do not place inflammable objects near the compressor.
- Never aim the air jet at people or animals
- Do not transport the compressor while the tank is pressurised.
- Be careful with regard to some parts of the compressor such as the head and delivery tubes, as they can reach
high temperatures. Do not touch these parts to avoid burns.
- Transport the compressor, lifting or pulling it with the appropriate grips or handles.
- Keep children and animals well away from the machine operating area.
- If using the compressor for painting:
a. Do not work in closed environments or near to naked flames
b. Make sure there is adequate exchange of air at the place of work
c. Protect your nose and mouth with an appropriate mask. (fig. 14)
- Do not put objects or your hands inside the protective grilles to avoid injury or damaging the compressor.
- When you have finished using the compressor,always switch it off.
◊ 4.8 Use of electrical sockets
Avoid all risks of electrical shocks:
Never use the compressor with damaged electrical cables or extension cables.
Regularly check the electrical cables.
Never use the compressor in or near water or near a hazardous area.
Check the tools absobtion connected to the sockets is NOT equal or hi-
gher than the data plate rates
MSU 678
The machine generates electricity at 230V single phase (2 sockets).
Generator is protected from overload, if necessary reset button must be
pressed.
MSU 598
The machine generates electricity at 230V single phase (1 socket) and
three-phase 400V (1 socket).
Generator is protected from overload, by an internal thermal cut-out.
Carefully read the generator user's manual for further info
HP/CV dB(A)
11 / 8 97
15
EN
EN