Steam For Heating Drinks; Maintenance And Daily Cleaning - Siemens TK 52 Serie Intrucciones De Uso

en
14
Steam for foaming milk
The appliance must be ready for use. You
can foam the milk first and add the coffee
on top, or foam the milk separately and
pour it into the coffee.

Risk of burns
!
The nozzle gets very hot. Do not touch the
metal parts!
● Push the sleeve on the nozzle 8 all the
way down.
● Fill the cup approximately 1/3 full of milk.
● Press the steam button
start to flash.
The appliance will heat up for approx.
i
20 seconds.
● Immerse the nozzle 8 deep into the milk,
but do not let it touch the bottom of the
cup.
● As soon as the
J
dial 6 to
/ .
g h

Risk of scalding
!
When the dial 6 is set to
8 may sputter. Escaping steam is very hot
and may cause liquids to sputter. Do not
touch the nozzle 8 or point it at anyone.
● Rotate the cup slowly until the milk is fully
foamed.
● End the process by turning the dial 6
back to O.
T o foam more milk, press the steam
i
button again and repeat the whole
h
process.
Note: When the nozzle 8 has cooled
down, clean it immediately. Dried residue is
difficult to remove.
Tip: If possible, use cold low­fat (1.5% fat)
milk.
14
. The LED will
h
LED flashes, turn the
/ , the nozzle
g h

Steam for heating drinks


Risk of burns
!
The nozzle gets very hot. Do not touch the
metal parts!
The appliance must be ready for use.
● Push the sleeve on the nozzle 8 all the
way up.
● Press the steam button
start to flash.
The appliance will now heat up for
i
approx. 20 seconds.
● Immerse the nozzle 8 deep into the liquid
you want to heat.
● As soon as the
J
dial 6 to / .
g h

Risk of scalding
!
When the dial 6 is set to
may sputter a little. Escaping steam is very
hot and may cause liquid to sputter. Do not
touch the nozzle 8 or point it at anyone.
● End the process by turning the dial 6
back to O.
T o generate more steam, press the steam
i
button again and repeat the whole
h
process.
Note: When the nozzle 8 has cooled down,
clean immediately. Dried residue is difficult
to remove.
Maintenance and daily
cleaning

Risk of electric shock
!
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
● Wipe the outside of the appliance with a
damp cloth. Do not use scouring agents.
● Wash all removable parts by hand only.
● Rinse out the water tank 11 with water
only.
● Remove, empty and clean the trays for
coffee grounds 17 and residual water 18.
. The LED will
h
LED flashes, turn the
/ , the nozzle 8
g h
en